Troubleshooting - American Sanders Clarke 07104A Manuel De L'utilisateur

Troubleshooting

Problem
Drive belts slip.
(Squeaking or squealing sound)
Squealing, growling or grinding
noise coming from machine.
Dust pickup is poor.
Motor will not start.
Motor runs sluggishly.
Motor circuit breaker trips/
repeatedly trips.
Uneven cuts.
®
Clarke American Sanders Operator's Manual (EN) - Floorcrafter
Cause
Insuffi cient tension.
Worn belts.
Damaged and/or worn bearing.
Dust bag is full.
Dust bag is dirty.
Dust shoe is improperly adjusted.
Dust chute is obstructed.
Defective motor starter.
Defective start capacitor.
Defective electronic start switch.
Low voltage from poor connection.
Defective motor.
No power.
Tripped circuit breaker.
Low voltage from excessive
footage, undersized extension
cord, or poor connection.
Defective run capacitor.
Defective motor.
Excessive load.
Defective electronic start switch.
Defective motor starter.
Low voltage from poor connection.
Defective motor.
Defective capacitor.
Leveling out of adjustment.
Abrasive belt tracking.
ENGLISH
Action
Tension drive belt as described in
adjustment procedures.
Replace belts.
Remove drive belts, rotate arbor
motor, fan, shafts and idler pulley to
locate dragging or rough bearing.
Contact an authorized dealer.
Empty contents of bag.
Shake debris from bag and wash.
Readjust dust shoe.
Remove fan cover and clear throat.
Contact an authorized dealer.
Contact an authorized dealer.
Contact an authorized dealer.
Contact an authorized dealer.
Contact an authorized dealer.
Check electrical source and
connections.
Reset
Locate power source nearer to work
site. Decrease sanding pressure.
Contact an authorized dealer.
Contact an authorized dealer.
Contact an authorized dealer.
Contact an authorized dealer.
Contact an authorized dealer.
Contact an authorized dealer.
Contact an authorized dealer.
Contact an authorized dealer.
Readjust leveling.
Adjust belt to track towards the edge
of drum with deepest cut.
FORM NO. 70255B - 19 -
EN