Marmitek Homeguard MS800 Guide Utilisateur page 7

2. Press 1 on the keyboard of the HomeGuard: One high tone is given for confirmation.
3. Press the ARM button on your remote: One low tone is given for confirmation.
Repeat step 1-3 for a second up to fourth remote if required.
4. Press any button on your HomeGuard keyboard to finalise the registration procedure: One
short low tone is given and the green indicator stops flashing.
If no successive commands are entered within a period of 15 seconds, the base station returns
to normal operation. To restart the registration you start the procedure from step1.
8. deLaY arm
The alarm mode may be activated by either the remote control or by the keyboard. If the
remote control is used, the HomeGuard arms and disarms instantly. If you require a delay, in
order to allow yourself to leave or enter the room before arming or disarming the HomeGuard,
you may set the HomeGuard to Delay Arm:
1. Enter your PIN (Personal Identification Number). Factory default is [0000]: You will hear
three high tones and one low tone as confirmation. The green indicator starts flashing.
2. Press 7 on the keyboard of the HomeGuard: One low tone is given for confirmation.
3. Press [ * ] for Delay Arm or # for Instant Arm: One tone is given for confirmation and the
indicator stops flashing.
9. sIreN
Your HomeGuard is equipped with a built-in siren. This siren will frighten intruders so they'll
leave the house. If you require a so-called silent alarm (without siren), you can change the
factory default:
1. Enter your PIN (Personal Identification Number). Factory default is [0000]: You will hear
three high tones and one low tone as confirmation. The green indicator starts flashing.
2. Press 3 on the keyboard of the HomeGuard: One low tone is given for confirmation.
3. Press [ * ] for Siren On or # for Silent Alarm: One tone is given for confirmation and the
indicators stops flashing.
10. de-aCTIVaTINg The BuILT-IN moTIoN seNsor:
If you prefer to operate the HomeGuard only by means of the external alarm connector rather
than the built-in motion sensor, you can de-activate the PIR:
1. Enter your PIN (Personal Identification Number). Factory default is [0000]: You will hear
three high tones and one low tone as confirmation. The green indicator starts flashing.
2. Press 6 on the keyboard of the HomeGuard: One low tone is given for confirmation.
3. Press [ * ] for activating the PIR or # for de-activating the PIR: One tone is given for
confirmation and the INDICATOR stops flashing.
11. oPeraTINg INsTruCTIoNs:
arm-disarm
The HomeGuard may be armed and disarmed by the remote control or keyboard.
HomeGuard™ 7