Maintenance; General Maintenance; Replace The Blade; Store The Machine - GreenWorks POWERALL MO48L2211 LME472 Manuel De L'utilisateur

10

MAINTENANCE

WARNING
Remove the safety key and battery pack from the machine
before maintenance.
WARNING
Keep the motor and battery pack free from grass, leaves or
too much grease.
CAUTION
Use only approved replacement parts.
CAUTION
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
CAUTION
Do not use strong solvents or detergents on the plastic
housing or components.
10.1

GENERAL MAINTENANCE

• Before each use, examine the machine for damaged,
missing, or loose parts such as screws, nuts, bolts and
caps.
• Tighten correctly all the fasteners and caps.
• Clean the machine with a dry cloth. Do not use water.
10.2

REPLACE THE BLADE

21
19
18
WARNING
Use only approved replacement blade.
English
20
Wear heavy gloves or wind cloth around the blade when
you touch the blade.
1. Stop the machine.
2. Make sure that the blade fully stops.
3. Remove the safety key and battery pack.
4. Turn the machine to its side.
5. Use a piece of wood to prevent the movement of the
blade.
6. Remove the blade bolt (18), the spacer (19) with a
wrench or socket.
7. Remove the blade (20) and fan (21).
8. Install the new blade as shown in the figure. Make sure
the arrow-shaped holes on the blade engage the posts on
the fan.
9. Put in the spacer and tighten the balde bolt.
10.3

STORE THE MACHINE

• Clean the machine before storage.
• Make sure the motor is not hot when you put the machine
into storage.
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person of an approved service center.
• Store the machine in a dry area.
• Make sure that children cannot come near the machine.
You may lower the handle(s) before you put the machine into
the storage.
1. Fully loosen the handle fasteners on the sides of the
handle(s).
2. Fold away the handle(s).
3. Do not pinch or trap the cables.
11

TROUBLESHOOTING

Problem Possible cause
The handle is not The bolts are not
in position. engaged correctly.
11
WARNING
Solution
Adjust the height
of the handle and
make sure that the
knobs and bolts
are aligned cor-
rectly.
EN