Putting Into Service; Air Supply - Avdel Genesis 7537 Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

P u t t i n g i n t o S e r v i c e
A i r S u p p l y
All tools are operated with compressed air at an optimum pressure of 5.5 bar. We recommend the use of pressure regulators and
filtering systems on the main air supply. These should be fitted within 3 metres of the tool (see diagram below) to ensure maximum
tool life and minimum tool maintenance.
Air supply hoses should have a minimum working effective pressure rating of 150% of the maximum pressure produced in the system
or 10 bar, whichever is the highest. Air hoses should be oil resistant, have an abrasion resistant exterior and should be armoured
where operating conditions may result in hoses being damaged. All air hoses MUST have a minimum bore diameter of 6.4 millimetres
1
or
/
inch.
4
Read servicing daily details page 21.
STOP COCK
(USED DURING MAINTENANCE
OF FILTER/REGULATOR UNIT)
3 METRES MAXIMUM
TAKE OFF POINT
FROM
MAIN SUPPLY
8
PRESSURE REGULATOR
AND FILTER (DRAIN DAILY)
MAIN SUPPLY
DRAIN POINT
7

Publicité

Chapitres

Table des Matières
loading

Table des Matières