Registering Hdmi Components To Tv; Changing The Connection Method And Connected - Yamaha YHT-S401 Mode D'emploi

Operating the unit by TV's remote control
Registering HDMI components to
*4
TV
1
Select this unit as the input source of the TV.
2
Turn on the HDMI control function supported
component (example: BD player) connected
to this unit.
3
Select the input source of this unit to BD
player and check whether the image in the
player is correctly displayed or not.
When connecting BD player with HDMI 1 jack,
press input selector button repeatedly to select
"HDMI 1".
4
Check if the HDMI control function works
(turn on this unit or adjust the volume level
using the remote control of the TV).
y
*4
For some HDMI components, you only need to set the HDMI
control function. Registering HDMI components to TV is not
required in this case.
If the HDMI control function is not working
Check the following:
– The TV is connected to the HDMI OUT (ARC) jack
of this unit.
– "3-1:CONTROL" in the "3:HDMI SETUP" is set to
"ON" in setup menu. (☞ P. 19)
– The HDMI control function is enabled on the TV.
(Also check the relative settings such as power
interlock function or speaker priority.)
The HDMI control function is not working even
checking the above,
– Turn off this unit and the TV, and then turn them
back on again.
– Disconnect the AC power supply cable of the unit
and external components connected to the unit with
HDMI.
Plug them in again after about 30 seconds.
– After selecting HDMI 1, HDMI 2 or HDMI 3,
change the input of TV and the one of this unit to
the same input.
24
En
Changing the connection method
and connected components
When the connected components and jacks are changed,
reset this unit with following procedures.
1
Turn off the HDMI control function of the TV
and player, turn off all connected devices,
and change the connections.
2
Perform the step 1 to 3 of "Setting the HDMI
control function".