S&P SPLIT 2000 PTC Instructions De Montage Et D'utilisation page 16

Before using the remote control, remove the plastic battery cover Fig. 4 –

A.
To change the remote control battery follow the instructions shown in Fig.

4 – B. Replace the battery with one of the same type CR2025 3V.
5. Operating warnings
The SPLIT-2000 PTC model is designed to operate under the following

ambient temperature conditions: -25°C / +40°C.
exceeded, the device will cease to function as a self-protection measure,
and the operating information display will show the following information:
To reactivate normal operation, disconnect the device from the mains
and reconnect it.
If the information display shows the errors: E1 or E2, contact the S&P

After Sales Service or your distributor.
6. Maintenance
Before carrying out any maintenance work, make sure that the device

has been disconnected from the mains and let the heater cool down
for a few minutes.
Periodically, clean the appliance with a dry cloth to remove the dust.

Do not use detergents or abrasive products.
Take down the device from the wall and, using a vacuum cleaner,

clean the dust from the intake grill and the air output openings.
Do not immerse the device or spray with water.

If the appliance is not to be used for any length of time, we

recommend returning it to its original package and storing it in a dry,
dust-free place.
E3: Ambient temperature under to -25ºC
E4: Ambient temperature high to +40ºC
16
If these limits are