S&P SPLIT 2000 PTC Instructions De Montage Et D'utilisation page 11

ENGLISH
SPLIT-2000 PTC
Please read these instructions carefully before using this heater in order
to avoid damage or any dangerous situations arising. Any use of the
product other than that indicated in this manual may cause fire,
electrical danger, or injury and will make the warranty null and void.
The warranty does not cover any defect, deterioration, loss, injury, or damage
that is due to incorrect use of the product. All legal rights in this regard are
guaranteed. No warranty condition can exclude or change the warranty
conditions regulated by State laws that may not be excluded or modified for
any reason.
Before doing anything else, remove the packaging carefully and check the
integrity of the product. Should any defects or damage be found, do not use or
attempt to repair the equipment, but contact the dealer.
Do not leave the packaging within reach of children and dispose of the parts in
compliance with
current provisions.
1. Safety instructions
Before connecting the applicance to the network, make sure that the

power supply corresponds to the details listed on the nameplate: 230V
~ 50Hz.
This product has been designed as a mobile heater or wall mounting.

It is designed as an auxiliary heat source and should be used only for
this purpose.
Flammable objects (curtains, furniture, plants, etc. ) should not be

placed at less than 3 metres from the appliance.
The heater must not be placed in a recessed place, where it interferes

with the free circulation of air, both the inlet and outlet.
11