S&P SPLIT 2000 PTC Instructions De Montage Et D'utilisation page 14

3. Installation
Before proceeding to install the machine, ensure that minimum

installation measurements detailed in Fig 2 are adhered to.
With a Ø6 drill bit, make 2 holes in the wall as per the dimensions

shown in Fig 3.
Insert the wall plugs into the holes and screw in the two L-shaped

hook screws (supplied), until they protrude 10mm.
Hang the heater on the two screws and gently move it towards the

right to ensure that it is securely fastened to the screws and cannot be
accidentally dislodged.
Connect the plug to the power supply.

Warning: Before connecting the device to the mains, ensure that the
electrical supply meets the requirements detailed on the rating plate
located on the side of the product.
IMPORTANT FOR FRANCE:
When the heater is installed on the wall, the electrical connection must
be as
connection terminal
supply.
In damp rooms, bathrooms or kitchens, the terminal must be installed
at least 25 centimeters from the ground. Permanent connection
should only be carried out in
pole circuit breaker with a minimum of 3 mm
poles.
Electricity
shown in the following diagram: cut the cable and use a
Phase: Brown
Neutral: blue
between the
cable networks equipped with an all-
14
power cable and the electricity
contact opening on all
Power cable