Installations And Settings On The Server Pc; System Requirements - Ricoh RW-7140 PLOTBASE Instructions D'installation

SYSTEM REQUIREMENTS

II.

Installations and settings on the server PC

This chapter explains,
• what system requirements must be fulfilled for the server,
•
how to install the drivers and the program,
Attention: Adjustment of the settings in the operating system and installation of the program should only be
carried out by a user with administrator rights.
System requirements
Please read through the following recommendations carefully:
•
Operating system
Microsoft Windows Vista, 32 bit, ServicePack 1
Microsoft Windows XP Professional, 32 bit, ServicePack 3
Microsoft Internet Explorer >= 6.0, ServicePack 1
•
Processor
Minimum Celeron with 2 GHz
As the processor hardware changes fast in the market you can ask for an actual list if required
•
Front Side Bus
Minimum Celeron with min. 400 MHz
• PCI Express slot (X1)
If your computer does not fulfill this standard, it is possible that the plotter controller will not be identified
•
System memory
At least 2 GB RAM is required
• Hard disk
The hard disk should have at least 100 GB free memory
•
Network interface/configuration
10/100 Base T Ethernet (TCP/IP configuration necessary)
or Novell Netware 6.5 SP6 with Novell Client 4.91 SP3
•
DVD drive
• RW-7140 controller
Physical dimension: 120 mm x 100 mm
PCB dimension: 70 mm x 60 mm
•
Monitor
At least 1024 x 768 pixels resolution
1280 x 1024 recommended
8 RW-7140 Installation