Switching On And Turning Off; Setpoint Setting; Manual Defrosting - Bartscher 66104400 Mode D'emploi

TAVOLO FREEZER
15.
ENG

Switching on and turning off

To turn the refrigerator on it is sufficient to activate the switch in the ON position
with green light on. The display will flash for 3 seconds, then it will report the
temperature inside the cell and begin the cycle refrigerator. During the course of
this operation, the display you will show the LED light near the snowflake (No. 5)
and the LED light of the internal fan. (# 4)
To turn the refrigerator off it is sufficient to activate the switch in the OFF position
with green light off.

15.1 Setpoint setting

To display the setpoint value press the 8 key: "set" will appear. Pressing again the
8 key it will be shown the default value of the setpoint on the display. To change
the setpoint value act on the 1 and 2 keys within 15 seconds. To confirm the
change, press the 10 key.
With setpoint it is meant a temperature value to be achieved from the food with a
tolerance of 2°C higher.

15.2 Manual defrosting

To activate manual defrost it is sufficient to hold the 1 key for 5 seconds, then all
the led will turn off and it will light up the LED No. 5 and it will begin the defrost
cycle.
TROUBLESHOOTING
LABEL
Probe 1 broken
E1
Probe 2 broken
E2
(defrosting)
HIGH alarm
AH1
Temp. probe 1
TROUBLE
• reading of values
outside of the range
of operation
(cell) • broken probe /
short-circuit / door
open
• reading of values
outside of the range
of operation
• broken probe /
short-circuit / door
open
Fridge temperature
too much elevated
CAUSE
•Label E1
•Steady Alarm Icon
•Label E2
•Steady Alarm Icon
•The defrosting cycle will
end for time-out
•No effects on regulation
Ed.10/2011
RESULT
•Check probe type (NTC)
•Check probes wiring
• Substitute the probe
•Check probe type (NTC)
•Check probes wiring
•Substitute the probe
Wait the temperature
value red from probe 1
goes down of HAL.
SOLUTION
20