Battery Replacement - Wagan Tech FRED Light Guide D'utilisation

FRED Light by Wagan Tech
™

BATTERY REPLACEMENT

1. Unscrew the two screws completely on the bottom of the unit.
2. Note the orientation of the two tabs at top.
3. Pull firmly on the plastic tabs to remove the cover plate.
NOTE: The FRED Light has a very tight, waterproof seal. Initial
seal may be difficult to open. If you cannot do it with your
hands, you can use either a flat head screw driver or similar tool
to pry open the unit at the plastic tabs (flanges).
4. Replace the batteries in the proper orientation shown on the
battery holder. Always replace the whole set of batteries at one
time, taking care not to mix old and new ones or batteries of
different types.
5. Align the two tabs on the battery cover to the notches on the
outer enclosure. Cover will not seal properly if not aligned to the
notches.
6. Secure the screws to ensure proper seal.
Pull firmly on
plastic tabs
5
®
Pull firmly on
plastic tabs
©2015