Door reversibility
Before carrying out any operations, remove the
plug from the power socket.
To change the opening direction of the door,
proceed as follows:
•
To carry out the following operations, we suggest
that this be made with another person that will
keep a firm hold on the doors of the appliance
during the operations.
•
Open the door with the appliance in the upright
position. Unscrew the screws and remove the
door plastic trim.
•
Remove the little plastic cover from the door
plastic trim and refit on the opposite side (d).
•
Lay down the appliance back side down.
•
Remove the plastic hinge covers dx and sx (3).
•
Unscrew the upper hinge and remove it (1-2)
•
Unscrew the screw and remove the door stopper
(4).
•
Remove the door
•
Remove the ventilation grill (D).
•
Using a 10 mm spanner, unscrew the hinge pin
(E) and reassemble it on the opposite side of the
hinge;
•
Screw down the bottom hinge (E) on the opposite
side by using the screws previously removed.
•
Remove the plug (F) from the ventilation grill (D)
and replace it on the opposite side.
•
Re-assemble the ventilation grill (D).
•
Reinsert the door .
•
Pay attention that the front board of the doors are
parallel to the front board of the top.
•
Fix the door stopper on the opposite side (4).
•
Position and fix the upper hinge on the opposite
side (1-2)
•
Reinsert the 2 plastic hinge covers (3).
•
Lift up the appliance to vertical position.
•
Open the door and reposition the upper door
plastic trim with screws.
•
Fix the handles on the opposite side, insert the
plastic plugs into the holes left open that can be
found in the instruction for use bag.
3
2
1
4
E
E
F
D
F
F
F
35