Door Reversibility; Installing The Appliance - Electrolux ERN3213AOW Notice D'utilisation

14 www.electrolux.com

9.4 Door reversibility

1. Loosen and remove the upper pin
and the spacer.
2. Remove the door.
3. Remove the lower spacer.
4. Loosen the lower pin with a key.
5. Tighten the lower pin on the opposite
side.
6. Install the lower spacer.
7. Install the door.
8. Tighten the spacer and the upper pin.
All manuals and user guides at all-guides.com
Do a final check to make
sure that:
• All screws are tightened.
• The magnetic seal
adheres to the cabinet.
• The door opens and
closes correctly.
If the ambient temperature is
cold (i.e. in Winter), the
gasket may not fit perfectly
to the cabinet. In that case,
wait for the natural fitting of
the gasket.
In case you do not want to
carry out the above
mentioned operations,
contact the nearest
Authorised Service Centre.
The Authorised Service
specialist will carry out the
reversibility of the doors at
your cost.

9.5 Installing the appliance

CAUTION!
Make sure that the mains
cable can move freely.
1. If necessary cut the adhesive sealing
strip and then apply it to the
appliance as shown in figure.
x
2. Drill the unit using a Ø 2.5 mm drill
(10 mm max. penetration).
3. Fix the square fitting to the appliance.
x