Install Door (Optional) - Whirlpool ImPress LFB2611LT0 Instructions D'installation

Completing electrical connection
1. Twist-on connectors
2. Ground wire
1. Connect all power supply wires and ground wires to their
corresponding terminal box wires as listed in the table below.
Power supply wire:
white connects to
black connects to
grounding wire connects to
2. Tighten the clamp connector or conduit connector screws.
1
1. Clamp connector or conduit connector screws
3. Reinstall the terminal box cover with the wires inside the
terminal box. The cover must be outside the box on the left
side. Make sure no wires are pinched by the cover.

Install Door (optional)

For the recessed-mounted units, follow these instructions to
attach the optional door.
Door can be mounted on either the right or left side of the
cabinet.
1. Place one hinge 3 in. (7.6 cm) down from the top of the door
and mark where the screw holes are located.
3" (7.6 cm)
2. Place another hinge 3 in. (7.6 cm) up from the bottom of the
door and also mark the location of the screw holes.
3. Find the center of the cabinet, place the hinge at the center
and mark the location of the screw holes.
4. Drill the marked pilot holes in the door with a ¹/₁₆ in. drill bit.
5. Attach the hinges to the door using a screwdriver (electric
recommended) and the included #8 screws.
6. Turn the ironing station cabinet on its side.
7. Place the door flush against the unit and wrap the hinges to
1
2
8. Mark the place where the screw holes from the hinges are on
9. Drill the pilot holes in the side of the cabinet with a ¹⁄₁₆ in. drill
10. Attach the screws to the side of the cabinet with a
Terminal box wire:
white
1. Place the latch striker flush with the front of the cabinet and
black
green grounding
wire
2. Mount the striker plate with the two enclosed screws.
3. Place the roller catch centered with the striker plate ⁷/₈ in.
4. Mount with the two enclosed screws.
5. Center the screw with the slot in the roller catch for
6. Adjust the roller catch in or out for desired tension.
the outside of the cabinet. Door should be placed square with
the top of the cabinet.
NOTE: The edge away from the hinges may overhang slightly.
the cabinet side.
bit.
screwdriver (electric recommended) and the included #8
screws.
Latch installation
centered with the top shelf.
(2.3 cm) from the front face of the door.
1
7
/ "
8
(2.3 cm)
1. Front face of door
adjustment purposes.
NOTE: When opened fully, the attached door will not lie flush
with the side of the ironing station cabinet.
7