Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Use hinges mounted on the exterior to allow the door to swing
open as fully as possible and to allow the board to swivel.
Electrical Requirements
All electrical work must be done in accordance with all
applicable electrical codes.
Dedicated 120 Volt AC GFCI Circuit must be used for direct
wire.
UL or CSA approved strain relief.
Strain relief
INSTALLATION
INSTRUCTIONS
Choose the installation mode desired: cabinet mounting, or
recessed mounting.
Unpack Ironing Station
WARNING
Excessive Weight Hazard
Use two or more people to move and install
ironing station.
Failure to do so can result in back or other injury.
After removing the ironing station from the carton, locate the
automatic cutoff switch and remove the protective foam
covering.
1
1. Automatic cutoff switch
Cabinet Mounting
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or
electrical shock.
The dimensions of the ironing station unit are 14³/₈ in. (36.6 cm) x
47¹/₂ in. (120.7 cm) x 11¹/₂ in. (29.2 cm).
1. Drill ¹/₄ in. pilot holes in a triangular pattern in the top of the
ironing station box as shown in the following graphic.
NOTE: Drill slowly or add a backing piece to prevent chipping
of the cabinet interior.
3"
(7.6 cm)
2. Drill ¹/₄ in. pilot holes in the bottom of the ironing station box
as shown in the following graphic.
3"
(7.6 cm)
6
7
/
" (17.5 cm)
8
TOP
7"
(17.8 cm)
7
3
/
"
4
(19.7 cm)
3"
(7.6 cm)
FRONT
BOTTOM
7
3
/
"
3"
4
(19.7 cm)
(7.6 cm)
3"
(7.6 cm)
FRONT
3
Publicité
Table des Matières
