Installation Requirements; Tools And Parts; Location Requirements - Whirlpool ImPress LFB2611LT0 Instructions D'installation

Tip Over Hazard
Ironing station is top heavy and tips easily when
not completely installed.
Use two or more people to move and install
ironing station.
Failure to do so can result in serious injury
or cuts.
INSTALLATION
REQUIREMENTS

Tools and Parts

Assemble the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools Needed
Stud finder (optional)
Carpenter's level
Phillips screwdriver
Small Phillips screwdriver
¹⁄₁₆ in. drill bit (for
mounting optional door
kit)
Parts Supplied
Look for the small pouch attached to the bottom bar of the
ironing board. This pouch contains the supplied parts.
5 #12 x 1¹/₂ in. screws for cabinet and recessed installation.
3 lag screws for surface installation.
Parts Needed
40w candelabra-style light bulb
Filler trim strips for cabinet mounting
2
Tape measure
Drill (electric
recommended)
Safety glasses
¹⁄₄ in. drill bit

Location Requirements

You must verify the default position of the ironing board before
installing the ironing center. Refer to the Ironing Board Height
Chart following for the proper height of the various installation
configurations.
Ironing Board Height Chart
Dimensions shown reflect mounting height above floor level.
(Mount cabinet above floor)
Desired board height range
38 in. (96.5 cm) to 42 in. (106.7 cm)
37 in. (94 cm) to 41 in. (104.1 cm)
36 in. (91.4 cm) to 40 in. (101.6 cm)
35 in. (88.9 cm) to 39 in. (99.1 cm)
34 in. (86.4 cm) to 38 in. (96.5 cm)
33 in. (83.8 cm) to 37 in. (94 cm)
32 in. (81.3 cm) to 36 in. (91.4 cm)
31 in. (78.7 cm) to 35 in. (88.9 cm)
30 in. (76.2 cm) to 34 in. (86.4 cm)
29 in. (73.7 cm) to 33 in. (83.8 cm)
28 in. (71.1 cm) to 32 in. (81.3 cm)
NOTE: The user can adjust height of board after installation with
a 4 in. (10.2 cm) differential between maximum and minimum
heights.
Installation Clearances
The ironing station board swivels in both directions. To ensure the
board is able to swing into position properly, allow 24 in. (61 cm)
on each side of the board.
24"
(61 cm)
Lower shelf
mounting height
above floor
30 in. (76.2 cm)
29 in. (73.7 cm)
28 in. (71.1 cm)
27 in. (68.6 cm)
26 in. (66 cm)
25 in. (63.5 cm)
24 in. (61 cm)
23 in. (58.4 cm)
22 in. (58.9 cm)
21 in. (53.3 cm)
20 in. (50.8 cm)
24" (61 cm)
24" (61 cm)