Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3. Remove the two screws from the cover of the electrical
junction box located in the bottom section of the cabinet.
NOTE: Pigtails are provided inside the junction box located
underneath the lower shelf for hookup to the supply line.
4. Remove the knockout for the appropriate wiring entrance
location.
NOTE: For cabinet mounting, the wiring will enter from the
back of the ironing station unit.
5. Before putting the unit into place, install a strain relief in the
location where the knockout was removed.
6. Make sure the supply wire is in a location to thread through
the wiring opening in the ironing station approximately 4³/₄ in.
(12.2 cm) from the bottom of the unit. A free wire length of 5 ft
(152.4 cm) is recommended.
2
1
/
"
8
(5.3 cm)
3
4
/
"
4
(12.2 cm)
1. Cabinet
7. Begin installation by picking up the ironing station unit with
one hand grasping the bottom bar of the ironing board and
the other hand on the top back of the ironing station.
8. As you are placing the ironing station into its location, feed
the wire through the strain relief.
4
9. Place the ironing station box inside the cabinet and slide it to
1
10. Check to see whether the ironing station is level by placing a
11. Mount the unit to the top shelf using three #12 x 1¹⁄₂ in.
12. Mount the unit to the bottom shelf using two #12 x 1¹⁄₂ in.
the side wall opposite the hinges and flush with the front of
the cabinet. Feed the wiring through the strain relief while
sliding the unit into the cabinet.
NOTE: Filler trim strips may be added to cover any open
space left after the unit is in place in the cabinet.
1. Nominal height - 26 in. (66 cm)
2. Minimum inside dimension - 17.4 in. (44.1 cm)
3. Depth - 24 in. (61 cm) or 12 in. (30.5 cm) minimum
level against the front face and top shelf of the unit.
NOTE: Shim the bottom of the unit to make the top of the unit
reach the underside of the top cabinet shelf. If it is not level,
correct by further shimming.
Phillips screws in a triangular pattern. When screwing the
screws into the top shelf, screw in the two front screws first.
When they are in place, screw in the third screw.
Phillips screws.
1
2
3
Publicité
Table des Matières
