Assembly - Domair FT-30ME2 Manuel D'utilisation

aSSEmBLy

iNStaLLiNG tHE Foot
and the washer 8 may be delivered se-
parately in a plastic bag.
Rev 0–12 11 19
1- Remove the tilt
adjustment bolt
4 by unscrewing
the knurled
knob 11.
2- Remove the
screw and
washer from
the bottom of
the foot's leg.
Note: The screw 7
Fabriqué en Chine
1. Control of oscillation
2. on/off button + speed selector
3. tilt lock button
4. Tilt adjustment bolt
5. top of the foot
6. leg of the foot
7. washer
8. Base mounting screw
9. assembled head
10. Tilt lock screw
11. Tilt adjustment button
12. Base
3- assemble the foot's leg on the base.
Do not forget to position the washer 7
as shown in the drawing.
4- Secure the base by firmly tightening
the screw 8 by hand.
5- Flip the foot over and place it on its
base on a flat, stable surface.
iNStaLLiNG tHE HEaD
oN tHE Foot
Using a Phillips screwdriver, remove the
small locking screw 10.
then remove the lock button 3.
note: it is important to correctly orient
the leg of the foot and the fan head du-
ring assembly.
Page 20