Tilt; Oscillation; Maintenance - Domair FT-30ME2 Manuel D'utilisation

tiLt

1. For your safety, make sure the fan
is in the off position before tilting the
grille.
2. Slightly loosen the two knurled knobs
3 and 11 (see paragraph «asseM-
BlinG the head on the Foot»)

oSciLLatioN

oscillation is started by the oscillation
button located on the top of the power
unit. Press the control knob to engage
the oscillation. Make sure that the grilles

maiNtENaNcE

• The appliance must be cleaned and
checked regularly. no disassembly
is normally necessary. However, the
front guard and strapping can be easily
removed if the blades need to be clea-
ned (see below)
• BEFORE SERVICING,
unPluG the PoweR CoRd!
• Take care that water or other liquids do
not come in contact with the motor or
any other electrical parts during clea-
ning.
• Use a soft, slightly damp cloth to clean
your fan, and then dry it.
• Do not use THINNERS, ALCOHOL or
otheR CheMiCals.
• Protective guards must be cleaned
with a vacuum cleaner or soft brush.
Rev 0–12 11 19
3. Gently pull the head up or down at the
desired angle.
4. Fix the unit back in place by tighte-
ning the 2 knurled knobs by hand.
do not touch anything during the oscil-
lation.
Pull on the control knob to stop the oscil-
lation.
• If necessary, unscrew the small screws
on the perimeter of the rear guard.
Remove the front guard and the strap-
ping. Clean the blades with a vacuum
cleaner.
ALWAYS
• Reassemble the front guard and the
strapping after cleaning. Make sure
all screws are in place and properly
tightened before use.
neVeR use the Fan without its
PRoteCtiVe GuaRds.
Fabriqué en Chine Page 22