Beurer EM 59 Heat Mode D'emploi page 35

2. Select the TENS 13 program as described in section "5.2 Starting
use" (step 3 to step 5).
˄/˅
3. Use the setting buttons to select the impulse frequency you
want and press the ENTER button to confirm your selection.
˄/˅
4. Use the setting buttons to select your preferred impulse
width and press the ENTER button to confirm.
˄/˅
5. Use the setting buttons to select the treatment time you
want and use the ENTER button to confirm.
˄/˅
6. Use the left and right
select the impulse intensity you want.
TENS 14 program
The TENS 14 program is a burst program that you can also
customise. Various impulse sequences run in this program. Burst
programs are suitable for all areas of application to be treated
with changing signal patterns (to minimise the level of becoming
accustomed to the treatment). In this program you can set an
impulse width of between 80 and 250 µs.
1. Place the electrodes on the desired area for treatment (for
positioning suggestions see electrode positions in section "7.4
Information regarding the positioning of electrodes") and connect
them to the device.
2. Select the TENS 14 program as described in section "5.2 Starting
use" (step 3 to step 5).
˄/˅
3. Use the setting buttons to select your preferred impulse
width and press the ENTER button to confirm.
˄/˅
4. Use the setting buttons to select the treatment time you
want and use the ENTER button to confirm.
˄/˅
5. Use the left and right
to select the impulse intensity you want.
TENS 15 program
TENS 15 is a program that you can also customise. In this program,
you can set the impulse frequency to between 1 and 150 Hz.
setting buttons for and
setting buttons for and
The impulse width changes automatically during the stimulation
treatment.
1. Place the electrodes on the desired area for treatment (for
positioning suggestions see electrode positions in section "7.4
Information regarding the positioning of electrodes") and connect
them to the device.
2. Select the TENS 15 program as described in section "5.2 Starting
use" (step 3 to step 5).
˄/˅
to
3. Use the setting buttons to select the impulse frequency you
want and press the ENTER button to confirm your selection.
˄/˅
4. Use the setting buttons to select the treatment time you
want and use the ENTER button to confirm.
5. Use the left and right
select the impulse intensity you want.
EMS 33 program
EMS 33 is a program that you can also customise. In this program,
you can set the impulse frequency to between 1 and 150 Hz and the
impulse width to between 80 and 320 µs.
1. Place the electrodes on the desired area for treatment (for
positioning suggestions see electrode positions in section "7.4
Information regarding the positioning of electrodes") and connect
them to the device.
2. Select the EMS 33 program as described in section "5.2 Starting
use" (step 3 to step 5).
˄/˅
3. Use the setting buttons to select the impulse frequency you
want and press the ENTER button to confirm your selection.
˄/˅
4. Use the setting buttons to select your preferred impulse
width and press the ENTER button to confirm.
˄/˅
5. Use the setting buttons to select the treatment time you
want and use the ENTER button to confirm.
6. Use the left and right
to select the impulse intensity you want.
35
˄/˅
setting buttons for
˄/˅
setting buttons for
and to
and