Assembly And Commissioning - Multiplex SAFETY SWITCH PRO Mode D'emploi

5. Assembly and commissioning

1. Attach the SAFETYSWITCH PRO power supply to the model so that it is protected from vibrations and shocks.
2. Connect the UNI connection cable (RX) to the battery slot of your receiver. Connect the second UNI connection cable (RX) to any free servo slot or, if
applicable, to the second battery slot of the receiver.
Note !
When connecting the UNI connection cable (s) (RX), ensure that the plug-in direction is correct, especially when using third-party products
Pay attention to compatible contact assignment.
SAFETYSWITCH PRO TwinBatt (M6): Connect the two-core connection cable (RX) to the M6 socket
and the M6 plug of the MULTIPLEX receiver RX- 9/12/16-DR pro M-LINK.
3. When using the safety switch, place it anywhere in the model, as far as possible protected against accidental actuation.
Connect the 4 - 6 cell NiXX or 2S LiXX battery pack (s) to the connection (s) of the SAFETY-SWITCH PRO marked with «BATT».
Pay attention to correct polarity.
4. The enclosed LED cable can be installed in the model or led outside.
To do this, a 3mm hole must be drilled, then you can fix the LED flush with the outer wall of the fuselage with a drop of Zacki from the inside.
13