Multiplex SAFETY SWITCH PRO Mode D'emploi page 11

2. Features
High-voltage power supply (input voltage = output voltage)
· SMD technology, long-life, vibration-resistant
· High-quality gold-plated connector systems and large cable cross-sections
· High continuous current load capacity thanks to large-area cooling via the milled aluminum housing
· Low power dissipation due to «ideal» diodes simulated by FET.
· Safe battery connection through MPX M6 connector and safety clips
· Compact construction and elegant design
· Fail-safe: If the switch or its connection cable is defective, the electronics ensure that the switching state is ON
I.e. Even if the switch vibrates down during flight, the power supply to the RC system is still ensured.
· Two receiver connection cables for double the wire cross-section and double the number of contacts with SAFETY-SWITCH PRO
· MPX M6 high-current connection with SAFETY-SWITCH PRO TwinBatt (M6) for direct connection to the MULTIPLEX receiver RX-9/12/16-DR pro
M-LINK or other receivers established on the market with M6 input.
· Integrated battery switch in the SAFETY-SWITCH PROTwinBatt. The batteries are discharged simultaneously and evenly.
If one battery fails, the second battery takes over the receiver power supply alone.
· It is also possible to connect a BEC of an ESC controller and a buffer battery. With this combination, make sure that the BEC voltage is higher than the voltage
of the buffer battery. e.g .: The BEC voltage is 8v, then the backup battery is discharged down to 8v, from then on only the BEC will be discharged. If the BEC
should collapse, the backup battery will be discharged again.
· Switch connection socket for free selection of your MPX switch.
(Magnetic safety switch / Professional safety switch / Micro safety switch)
· LED status display on the housing
· Additional plug-in LED cable with a modern 3mm flat head LED to display the switching status.
11