Murray 6210701x54NA Manuel De L'utilisateur page 7

CONTENTS
HAZARD SYMBOLS AND THE MEANINGS
OPERATING SYMBOLS AND THEIR MEANINGS
RULES FOR SAFE OPERATION
ASSEMBLY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
OPERATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
MAINTENANCE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
MAINTENANCE CHART . . . . . . . . . . . . . . . . . . . . . . . . . . .
TROUBLE SHOOTING CHART
LIMITED WARRANTY . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
General Information
This instruction book is written for a person with some mechanical ability.
Like most service books, not all the steps are described. Steps on how to
loosen or tighten fasteners are steps anyone can follow with some
mechanical ability. Read and follow these instructions before you use the
unit.
Know your product: If you understand the unit and how the unit
operates, you will get the best performance. As you read this manual,
compare the illustrations to the unit. Learn the location and the function of
the controls. To help prevent an accident, follow the operating instructions
and the safety rules. Keep this manual for future reference.
IMPORTANT: Many units are not assembled and are sold in cartons. It is
the responsibility of the owner to make sure the assembly instructions in
this manual are exactly followed. Other units are purchased in an
assembled condition. On assembled units, it is the responsibility of the
owner to make sure the unit is correctly assembled. The owner must
carefully check the unit according to the instructions in this manual before
it is first used.
www.briggsandstratton.com
MODEL NO.: 6210701x54NA
SKU No.:
YYYY MM DD:
SERIAL NO.:
30 kg
3500 min-1
Assembled in Suzhou, China 215218
by Limac for Briggs & Stratton Corporation
1741413
. . . . . . . . . . 8
. . . . . 8
. . . . . . . . . . . . . . . . . . . . 9
11
11
13
13
. . . . . . . . . . . . . . . . . . . . . 15
16
Declared vibration emission values in accordance with Directive 98/37/EC.
Values determined at the handle when the machine was operated stationary on a
concrete surface at 3500 min- -1.
Declared airborne noise emissions of Lw
2000/14/EC, Annex V.
Values determined at ear according to the specifications of EN ISO 11201.
Controls & Equipment Features (see Figure 1)
Crank Assembly (2) - - Changes the direction of the discharge chute.
Chute Deflector (3) - - Changes the distance the snow is thrown.
Discharge Chute (4) - - Changes the direction the snow is thrown.
Auger Drive Lever (5) - - Starts and stops the auger (snow gathering and
throwing) which also propels the snowthrower..
Engine Features
Stop Switch (8) - - If equipped, move to the ON position to start the
engine.
Primer Button (9) - - Injects fuel directly into the carburetor for fast starts
in cold weather.
Recoil Starter Handle (12) - - Use to manually start the engine.
Choke Control (14) - - Use to start a cold engine.
Vibration Emission according to EN 1033;1996: 11,6 m/s
Sound Pressure Level at operator position 84,4 dB.
Declared airborne sound
power level of 104 dB(A) is in
accordance with Directive
2000/14/EC.
7
2
.
104 dB is in accordance with Directive
A
en