Uberhaus 68125104 ECH110 Guide De L'utilisateur page 4

IMPORTANT SAFETY INSTRUCTIONS
10.When mounting the unit, make sure that the anchor used can support the total
weight of the unit with the mounting brackets.
11.When cutting or drilling into a ceiling, do not damage electrical wiring and other
hidden utilities.
12.When starting up the unit for the first time or after a long period, it might produce
some temporary odours and whitish smoke. This is normal.
13.Because this unit is hot when in use, it may pose risks even during normal
operation. Therefore, be careful and responsible when using it. To avoid burns, do
not let bare skin touch hot surfaces. The unit must cool down for few minutes since
it will stay warm for some time after shut down.
14.All units require a minimum mounting height of 8 feet (2.44 m) from finished floor.
Keep at least 12 inches (30 cm) away from any vertical surfaces or walls (see the
installation section). However, make sure flammable objects or pieces of furniture
do not come into contact with the unit and keep them at least 24 inches (61 cm)
from the unit since they are more flammable than walls and ceilings. Failure to
comply with this warning could lead to a fire. Some materials are more
heat-sensitive than others, so make sure those near the unit can withstand heat.
15.Never block unit air vents. This obstruction could lead to overheating, which could
result in a fire.
16.Do not insert or allow foreign objects to enter any air vent as this may cause electric
shocks, fires, or damages to the unit.
17.This unit has hot and arcing or sparking parts inside. It is not designed to be used or
stored in wet areas or areas containing flammable liquids, combustible materials or
corrosive, abrasive, chemical, explosive and flammable substances such as, but
not limited to, gasoline, paint, chlorine, sawdust and cleaning products.
18.Some areas are dustier than others. Thus, it is the user's responsibility to evaluate if
the unit must be cleaned based on the amount of dirt accumulated on and inside air
vents. Accumulated dirt can lead to a component malfunction or discoloration
(yellow). It may cause a fire hazard if not installed and maintained in accordance
with these instructions.
19.The thermal protection activation indicates that the unit has been subjected to
abnormal operating conditions. If the thermal protection remains activated or
activates and deactivates repeatedly, it is recommended that a qualified electrician
or a certified repair centre examine the unit in order to make sure it is not damaged.
(Refer to the limited warranty)
20.If the unit is damaged or defective, cut off power supply at circuit breaker/fuse and
call a certified repair centre. (Refer to the limited warranty)
21. Use this heater only as described in this manual. Any other use not recommended
by the manufacturer may cause fire, electric shock, or injury to persons.
3