Cleaning And Storage - Gourmet Maxx 09108 Mode D'emploi

10. If the device is no longer going to be used, pull the mains plug out of the plug socket
and place the motor unit to one side.
11. Take off the protective lid and remove the food from the collecting container. PLEASE
NOTE! Do not reach into the blades as you do this!

Cleaning and storage

PLEASE NOTE!
■ Remove the plug from the mains socket before cleaning the device.
■ All accessories, apart from the motor unit (!), can be cleaned in the dishwasher.
■ Do not clean the motor unit in the dishwasher!
■ Do not use any caustic or abrasive cleaning agents or cleaning pads. These could
damage the surfaces.
1. Pull the motor shaft (6, 7) off the receptacle for the motor shaft (A).
2. If necessary, carefully detach the stirring insert (4), the whisk (3) or the blade attach-
ment (2) from the motor shaft.
3. Wipe down the motor unit (8) with a slightly damp cloth and then dry it thoroughly.
6. Place the protective lid (5) on the collecting container.
Make sure that it fi ts correctly (see picture).
The silicone closure (B) on the protective lid is de-
B
signed to make sure that any food which is left over
can be stored in the collecting container for a short
time. It must not be fi tted over the opening for the
motor shaft during use.
7. Place the motor unit on the protective lid. Make sure that
it is placed on correctly. The latch must fi t in the recess on
the protective lid (see picture).
8. Press the On / Off switch (9) and hold it down. The motor
shaft rotates and the blades cut or the stirring insert or
whisk mixes up the food.
9. Let go of the On / Off switch once the food has been fully
chopped up or stirred together.
17 EN