gce mediline SABRE ELITE Série Mode D'emploi page 4

Use only the product and its associated equipment in well ventilated
area
Before initial use the product will be supplied in its original packing. If
removed from service (for transport, storage) GCE recommend using the
original packaging (including inner packing materials).
The product owner or user must ensure that during the product life cycle
transport and storage environmental conditions are in accordance with
gB the above "Safety instruction" section requirements, in order to maintain
product integrity and cleanliness.
Statutory laws, rules and regulations for medical gases, accident
prevention and environmental protection must be observed.
OPERATIng COnDITIOnS
In case of storage at a temperature below -20 °C, d o not operate the
regulator until it has been allowed to increase its temperature to a
minimum of -20 °C.
PERSOnnEL InSTRUCTIOnS AnD TRAInIng
4.
According to Medical Devices Directive 93/42/EEC the product owner
must ensure that all personnel handling the product are fully trained
to carry out that operation. Trainees need to be supervised by an
experienced person.
Do not use the device without a proper training provided by a GCE person
or GCE authorized person.
According to Medical Devices Directive 93/42/EEC the product owner
must ensure that all personnel handling the product are provided with the
instruction for use to carry out that operation.
-20/+60 °C
10/95%
600/1200 mbar
STORAgE AnD
TRAnSPORT COnDITIOnS
4/72
-20/+60 °C
10/95%
600/1200 mbar