Anion; Timer; Cool; Cleaning, Filling And Draining - M Confort Elite 14 Manuel De L'utilisateur

MCONFORT
IV.II.IV. ANION.
Press the icon
press the icon again
purifier)
IV.II.V. TIMER
Press the icon
icon is pressed, it will change 1H, 2H, 4H, 8H. (The unit will turn off automatically after 1H,
2H, 4H, 8H)
IV.II.VI. COOL
Turn on the COOL mode by pressing the icon
To turn off the COOL mode, press icon again
mode.
REMARKS: When the COOL mode is activated, the pump inside the water tank will pump
water to saturate the cooling pads. The heat that flows through the cooling pads will be
exchanged with the water and will cool the air flowing through the cooling pads to lower
the temperature. Therefore, a decrease in temperature depends on the relative humidity
and air temperature when the unit is in COLD mode. In the case where the fan speed is
high, when the icon is pressed, the fan will fall at the lowest speed for 30 seconds before
resuming the previously set speed.
V. CLEANING, FILLING AND DRAINING
Cleaning the dust filter and the cooling filter
14
on the control panel or the remote control to turn on the ANION mode,
, the system will stop the ANION function. (ANION is used for air
on the control panel or the remote control to set the timer. Each time the
ELITE 14 / ELITE 24
on the control panel or the remote control.
, the system will automatically exit COOL
Remove the side plug to which the dust
filter is connected and then remove the
cooling pad as indicated above.