Cleaning And Maintenance; Safety Advice; Cleaning - Bartscher 2000D I Mode D'emploi

•
Height of patio heater can be regulated (1,80 to 2,10 m). In order to effect this, pull up
the extension pipe
Next, set extension pipe, turning the base casting
•
In order to switch off device, pull the pull switch with heat-level indicator repeatedly,
until „0" becomes displayed on the indicator. Next, disconnect device by pulling the
plug out!

6. Cleaning and maintenance

6.1 Safety advice

o Before beginning with repair or cleaning works make sure the device has been
disconnected from power supply and has cooled down.
o Do not use any acid agents and make sure no water ingresses the device.
o To protect yourself from electric shock, never immerse the device, its cables and
the plug in water or other liquids.
CAUTION!
The device is not suited for direct washing via water jets.
Therefore, you must not use any kind of pressure water jet for cleaning the device!

6.2 Cleaning

o After long use, reflector may collect dust. Remove dust using a brush.
o Following device use, if necessary, dry cleanse device with a soft cloth.
o Only use a soft cloth and never use rough detergents which could scratch the
surface of the device.
o Store device in a dry place. Before storing device, make sure device is properly
cleansed.
③
from the upper pipe stand
⑦
, until desired height is reached.
⑥
in order to effect this.
- 27 -