Operation - Bartscher 2000D I Mode D'emploi

Connection
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with
that of the device (see type label).
Connect the device only in case of compliance!
Take note of the security advice!
•
The electrical circuit of the socket must be secured to at least 16A. Only connect
the device to a wall outlet; do not use any extension cords or power strips.
•
Place the device so that the plug is easily accessible so as to quickly disconnect the
device if the need arises.

5.3 Operation

•
Electric patio heater with quartz heater pipes is switched on by use of pull switch
with heat-level indicator light.
•
While device is being switched on, some vibration occurs that lasts for a few seconds.
•
During first use of pull switch with heat-level indicator light, the patio heater is set at
first degree: 650 W (standard-level energy).
•
Next action on the pull switch initiates the second degree: 1300 W (mid-level energy).
•
3rd degree: 2000 W (full power) becomes switched on by a third pull of the switch.
•
Patio heater inclination angle
(0° ~ 45° ). Before changing the inclination
angle (ill. 5), switch off device first and leave
it to cool off for 15 min.
WARNING! Burn hazard!
Patio heater extremely heated during use!
Never change inclination angle during use.
- 26 -
①
is regulated
①