Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
The specified values are emission
levels and are not necessarily to be
seen as safe operating levels.
As workplace conditions vary, this
information is intended to allow the user
to make a better estimation of the
hazards and risks involved only.
4.3 Content of delivery
Base assembly with motor
Sanding belt 60 grit
Sanding disc 60 grit
2 tables
Mitre gauge
Operating tools
Assembly kit
Operating manual
Spare parts list.
5. Transport and start up
5.1 Transport and installation
For transport use a forklift or hand
trolley. Make sure the machine does
not tip or fall off during transport.
The machine is designed to operate in
closed rooms and must be placed
stable on firm and levelled ground.
The machine can be bolted down if
required.
For packing reasons the machine is
not completely assembled.
5.2 Assembly
If you notice any transport damage
while unpacking, notify your supplier
immediately. Do not operate the
machine!
Dispose of the packing in an
environmentally friendly manner.
Clean all rust protected surfaces with a
mild solvent.
Mount the sander to the machine stand
and connect with 4 lock bolts, washers
and spring washers
(A, Fig 1).
Fig 1
Install the drive belt (C, Fig 2).
Adjust the belt tension by adjusting the
nuts (F, Fig 2).
Fig 2
Close and lock the cabinet door.
5.3 Mains connection
Mains connection and any extension
cords used must comply with
applicable regulations.
The mains voltage must comply with
the information on the machine licence
plate.
The mains connection must have a
16A surge-proof fuse.
Only use power cords marked H07RN-
F
Connections and repairs to the
electrical equipment may only be
carried out by qualified electricians.
5.4 Dust connection
Before initial operation, the machine
must be connected to a dust collector.
The suction should switch on
automatically when the belt sander is
switched on.
The flow rate on the 100mm suction
port must be 20m/sec.
Flexible hoses must be of non-
flammable quality, and must be
connected to the dust collector ground
system.
5.5 Starting operation
You can start the machine with the
green on button. The red button on the
main switch stops the machine.
6. Machine operation
Feed the workpiece straight across the
machine table, holding your fingers
close together, guiding the workpiece
with the palm of your hands.
Don't put your hands under the
machine table.
Always keep your hands well clear of
the moving sanding belt or disc.
When working complex shapes, make
jigs and guides to guide the workpiece
properly and safely .
Support long workpieces with helping
roller stands.
For bevel sanding the tables can be
tilted. Adjust the tables to keep a
distance between the sanding paper
and the table edge of 2 mm.
6.1 Vertical belt sanding:
When sanding in the vertical position,
the table attachment must be
positioned as sanding table (Fig 3).
The table can be tilted at any angle
between 90° and 45°
Publicité
Table des Matières
