Frequently Asked Questions/Troubleshooting - patura P4000 Mode D'emploi

clamped to the fence wires.
• The size of the warning sign shall be at least 100x200 mm (4x8").
• The background colour of both sides of the warning sign shall be yellow. The
inscription on the sign shall be black and shall be either like the illustra-
tion below or the substance of "CAUTION: Electric animal fence".
• The inscription shall be indelible, inscribed on both sides of the warning
sign and have a height of at least 25 mm (1").
Ensure that all mains-operated, ancillary equipment connected to the electric
fence circuit provides a degree of isolation between the fence circuit and the supply mains
equivalent to that provided by the energiser.
Protection from the weather shall be provided for the ancillary equipment unless this equipment
is certified by the manufacturer as being suitable for use outdoors, and is of a type with a
minimum degree of protection IPX4.

Frequently Asked Questions/Troubleshooting

What voltage is required to control animals?
4 kV is widely accepted as the recommended minimum voltage to control animals. However,
you also require a well constructed fence system to ensure that animals cannot push through
electrified wires.
The fence voltage is below 4 kV. How do I increase the voltage?
Check the energiser. Ensure that the energiser is not set on half power. Disconnect the
energiser from the fence and earth system. Measure the voltage across the energiser terminals
with a PATURA Remote Control Fence Compass, DVM or Fence Tester. If the voltage is less than
6 kV, request your PATURA service agent to check the energiser.
Check the energiser earthing. Use the procedure described in "Installing and testing an earth
system" on page 26.
Check your fence system for faults. The most common source of low voltage is faults on the
fence line.
If the fence, earth and energiser are in good condition and the voltage is still below 4 kV, talk
to your PATURA distributor. They will help you identify whether recent extensions to your fence,
a poor fence layout, or soil conditions may be causing inadequate voltage.
How do I locate faults?
The recommended tool for locating faults is the PATURA Remote Control Fence Compass. This
combined voltage and current meter allows you to rapidly locate sources of current leakage.
Alternatively, use a PATURA DVM or Fence Tester. Use cut-out switches to turn off the power to
- 30 -