Publicité
Les langues disponibles
Les langues disponibles
increase it.
After switching on, the temperature control should be set to position 5. After
approx. 20 minutes, the setting should be changed to position 3. This setting is
usually sufficient for normal use.
Following a power interruption, or if the unit has been switched off on purpose,
always wait 3 to 5 minutes before switching on again. The unit cannot be re-activated
without this delay.
Storing wine
- The temperature in the cabinet largely depends on factors such as the ambient
temperature, the setting and the number of wine bottles stored.
- Turn the temperature control to the desired position.
- Always ensure that the door is properly closed and that the seal is not obstructed by
bottles stored inside the cabinet.
De-frosting and cleaning
The integral evaporator is sealed in foam within the walls; you may therefore notice a build-
up of frost around the rear area. This layer of frost will start melting when the compressor is
not working. Through a system of hoses, the melt-water drains into the collection tray below
the compressor, where it will be absorbed into the surrounding air. The unit does not
therefore require de-frosting, but only proper cleaning.
●
To enable the melt-water to drain freely, always ensure that the channel and discharge
opening in the cabinet are free of any blockage.
Cleaning the unit / periods of non-use
- remove the plug from the wall socket
- remove the bottles from the cabinet
- leave the door open
To prevent any unpleasant odour within the cabinet, it should be cleaned at least every two
months. The surfaces and the drain channel may be cleaned with warm water. If necessary, a
mild detergent can be used. Wipe thoroughly dry and air out afterwards.
Take care not to remove or damage the rating plate inside the cabinet during cleaning.
Any dust deposits around the ventilation slots on the outside of the unit should be regularly
removed using a suitable brush or a vacuum cleaner. The build-up of dust will otherwise
cause an increase in energy consumption.
Remark: Do not use abrasive tools, materials containing alcohol or harsh cleaning solutions.
Do not use any electrical appliances, such as steam cleaners, for de-frosting or cleaning.
Trouble-shooting
Certain typical sounds can be heard when the appliance is switched on. These sounds are
caused by:
- the electric motor within the compressor assembly; during
compressor start-up the sound level will be slightly higher for
a short time.
- the cooling agent flowing through the circuit.
The following table lists possible malfunctions, their probable causes and solutions. In the
event of operational problems, check first whether a solution can be found using this table. If
12
Publicité
