The Product; Assembly - Montiss KJE5737M Mode D'emploi

THE PRODUCT

1.Pounder
2.Pulp container
3.Motor housing
4.Latch
5.Spout
6.Grater housing
7.Grater

ASSEMBLY


Remove all packaging materials.

Clean the device, if necessary, with a wet cloth and some mild detergent (also see the paragraph
"maintenance and cleaning").

Make sure all parts are clean and dry before assembling the device.
Warning: do not insert the plug into the electrical outlet and do not turn on the device before you
have completed the assembly.
Warning: please do not dismantle the grater! The parts could by tremble loose by using the device
which could be very dangerous!!
1. Place the motor housing (3) on a flat surface, e.g. a kitchen counter, and make sure it is stable.
2. Place the grater housing (6) on the motor housing so that the spout (5) fits in the slot on the
side of the motor section.
3. Push the pulp container (2) up under the edge of the grater housing so that it locks on the foot
of the motor housing tightly.
4. Carefully place the grater (7) in the grater housing. Be careful not to touch the sharp parts at
the bottom of the grater.
5. Make sure that the grater fits properly in the housing and the gear in the grater and housing
are connected properly.
6. Make sure the grater does not sit loosely on the base and that it rotates evenly.
7. Place the lid (10) on the appliance so that it covers both the pulp container and the grater.
Make sure that the lid fits tightly onto the grater housing.
8. Power cable with plug
9. Feeder
10. Lid
11. Speed control knob
12. Juice cup
13. Cleaning brush
23