EUROM HARSTAD Manuel D'utilisation page 21

There are four buttons on the remote control; one red and three black. The red
button switches the atmospheric screen on; the two upper black buttons are for
setting heat levels (1000 and 2000 Watt respectively) and the lower black button (the
dimmer) is used to regulate the clarity of the screen.
Please keep the instruction booklet somewhere safe for reference or for providing
with the device if it is sold on.
Location and Connection

Remove all packaging material and keep out of reach of children. After removing
packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact
your vendor for inspection or replacement.

Do not use the fireplace before it has been completely installed according to the
instructions and you have read the instruction booklet fully!

This device was designed to be permanently hung on a wall. Ensure the wall is
sturdy, completely vertical, is not sensitive to vibration and is not flammable.
Make sure it is not made of synthetic material and or covered with flammable
material. Be aware of pipes that may be contained within the walls when drilling
holes.

Choose a suitable location for the fireplace, at least one metre from all
obstructions, walls and flammable materials (see safety instructions) and in the
vicinity of a 16 Amp (at least) fused, earthed electrical socket (protected by a 30
mA earth leakage circuit breaker). This socket must be located to the right of the
fireplace.

There must be at least 30 cm distance between the base of the fireplace and the
ground, however, you are advised to place the fireplace at a height of 60 cm. for
the best sight. There must be at least 20 cm distance between the fireplace and
the side walls, at least 100 cm. between the fireplace and the ceiling. Do not
21