Evolution EVOMAG42 Notice Originale page 4

Note: The vibration measurement was made
under standard conditions in accordance with:
EN62841-1: 2015 and UL Std. 62841-1 and CSA
Std. C22.2 No. 62841-1
The declared vibration total value has been
measured in accordance with a standard test
method and may be used for comparing one
tool with another.
The declared vibration total value may also be
used in a preliminary assessment of exposure.
WARNING: that the noise emissions during
actual use of the power tool can differ from
the declared values depending on the ways
in which the tool is used especially what
kind of workpiece is processed; and
of the need to identify safety measures to
protect the operator that are based on an
estimation of exposure in the actual
conditions of use (taking account of all parts
of the operating cycle such as the times when
the tool is switched off and when it is running
idle in addition to the trigger time).
VIBRATION
WARNING: When using this machine the
operator can be exposed to high levels of
vibration transmitted to the hand and arm. It
is possible that the operator could develop
"Vibration white finger disease" (Raynaud
syndrome). This condition can reduce the
sensitivity of the hand to temperature as well
as producing general numbness. Prolonged or
regular users of this machine should monitor
the condition of their hands and fingers
closely. If any of the symptoms become
evident, seek immediate medical advice.
• The measurement and assessment of
human exposure to hand-transmitted
vibration in the workplace is given in: BS
EN62841-1: 2015
• Many factors can influence the actual
vibration level during operation e.g. the
work surfaces, condition and orientation
and the type and condition of the machine
being used. Before each use, such factors
should be assessed, and where possible,
appropriate working practices adopted.
Managing these factors can help reduce
the effects of vibration:
www.evolutionpowertools.com
Handling:
• Handle the machine with care, allowing
the machine to do the work.
• Avoid using excessive physical effort on
any of the machine's controls.
• Consider your security and stability, and
the orientation of the machine during
use.
Work Surface:
• Consider the work surface material;
its condition, density, strength, rigidity
and orientation.
WARNING: The vibration emission during
actual use of the power tool can differ from
the declared total value depending on the
ways in which the tool is used. The need
to identify safety measures and to protect
the operator are based on an estimation
of exposure in the actual conditions of use
(taking account of all parts of the operating
cycle, such as the times the tool is switched
off, when it is running idle, in addition to
trigger time).
LABELS & SYMBOLS
WARNING: Do not operate machine if
warning and/or instruction labels are missing
or damaged. Contact Evolution Power Tools
for replacement labels.
NOTE: All or some of the following symbols
may appear in the manual or on the product.
SYMBOL DESCRIPTION
V
A
Amperes
Hz
Min
-1
~
Alternating Current
n o
No Load Speed
4
Volts
Hertz
Speed