The Shark ® Backsaver ™ Folding; (Fig. 4); Fig. 4 - shark V2950 Manuel Du Propriétaire

USING YOUR CORDLESS FLOOR AND CARPET SWEEPER
Fig. 3
FLOOR
CARPET

Fig. 4

1 Press the On/Off button to start
the floor and carpet sweeper.
When finished cleaning, press
the On/Off button again to turn
the unit off. (fig. 3)
2 You can adjust the speed of
the brush roll to suit the floors
that you are cleaning. Press the
Fig. 5
Fig. 6
button on the right (opposite
the On/Off button) to switch
between speeds. One light
indicates the speed optimized to
clean bare floors and two lights
indicate the speed optimized to
clean carpets and larger debris
on bare floors. (fig. 4)
If the brush roll stops
moving, it's probably due
to the anti-jam feature.
This feature protects the
motor from becoming
overheated. If the brush
becomes overloaded, it
will stop turning and both
speed indicator lights will
stay on. Turn off your unit by
pressing the On/Off button
once. Then remove the brush
roll cover from the floor and
carpet sweeper base and
remove any hair or fiber
that may be on the brush
roll. Wait for 10 seconds
to let your unit cool down.
Now press the On/Off button
again and you're ready to
resume cleaning!
See page 13 for further
instructions on removing or
cleaning the brush roll.
3 To clean under furniture, use
the Shark Backsaver
®
handle. Press the handle
release button and apply a bit
of pressure to bend the handle
forward. (fig. 5) The Shark
Backsaver joint will release
™
from the locked position to
reach messes under furniture.
(fig. 6)
www.sharkclean.com
folding
™
®
11