shark V2950 Manuel Du Propriétaire page 13

MAINTENANCE
1 Once a month, wipe down your
unit with a dry cloth, including
the area under the dust cup.
Wipe away any hair, fiber or
other dirt that may have built
up in the chamber and on the
rotating brush. Do not use any
harsh sweeper or chemicals.
2 Do not immerse your floor and
carpet sweeper in water or use
it to pick up liquids or clean wet
floors. (Fig. 13)
3 Do not use it on concrete, tar or
other rough surfaces.
4 Do not use it to pick up pieces
of string or fabrics. (fig. 14)
Do not use the floor and carpet
sweeper to clean tasseled or
frayed carpets.
CLEANING THE ROTATING BRUSH
1 Press the dust cup release
lever with your foot and remove
it from the floor and carpet
sweeper base. (fig. 10)
2 Turn the unit upside down. Be
careful not to accidently turn
the unit on!
Fig. 13
Fig. 14
3 Remove all hair, strings or fibers
wrapped around the brush
bar. Using a pair of scissors,
carefully cut along the raised
guide to remove anything
wound around the brush bar.
Avoid damaging or cutting the
bristles. (fig. 15)
4 Use a coin to unlock and
remove the trap door. (Fig. 16)
5 Carefully lift and remove the
brushbar from the belt. (Fig. 17)
To reinsert the brushbar, slide
the brushbar into the bushing
and then place the belt over
the ridges of the brushbar cap.
Replace the trap door and lock
in place.
REMOVING AND REPLACING THE
BATTERY
1 Press the dust cup release
lever with your foot and remove
it from the floor and carpet
sweeper base.
(fig. 10 on page 12)
3
Fig. 15
Fig. 16
2 Turn the unit upside down. Be
Fig. 17
careful not to accidently turn
the unit on!
3 Push in the locking tab and lift
off the battery compartment
cover. (fig. 18)
4 Carefully lift out the battery
pack and disconnect the wire
terminals by pressing on the
latch and pulling apart the wire
terminal connectors. Remove
the battery pack. (fig. 19)
5 Connect the wire terminal from
the unit to the wire terminal
connector of the new battery
pack and replace the battery
pack into your unit.
6 Follow the instructions on page
12 to charge your new battery
pack. Please call customer
service at 1-800-798-7398
if you have any problems
removing the battery pack.
www.sharkclean.com
Fig. 18
Fig. 19
Ni-MH BATTERY
MUST BE RECYCLED
OR DISPOSED OF
PROPERLY
13