emerio PAC-125336.3 Mode D'emploi page 9

OPERATION
*Always let the appliance rest for at least 2 hours after moving it from one location to another.
Before use, check up whether the exhaust hose has been mounted properly. Plug in the appliance.
1. Power button
Press the power button to turn on the appliance. The room temperature will be shown on the display.
The appliance will start to work. The power indicator light turns on when the appliance is on.
Press the button again, the appliance will be turned off.
2. Temperature/timer increasing button & temperature/timer decreasing button
Press the button "
also be used for timer adjustment during timer setting. The value will be increased/decreased by 1 (℃
/hour) for each press.
3. Fan speed button
Press the fan speed button to switch the fan speed among low, medium and high speed. The
corresponding indicator light "LOW"/"MID"/"HIGH" will illuminate.
4. Mode button
Press the mode button to choose your desired working mode among AUTO, cooling, heating, drying and
fan mode. The corresponding indicator light will turn on when the specific mode is selected.
• Auto mode
In AUTO mode, the indoor temperature sensor operates automatically to select the desired operation with
cooling or fan: when the room temperature is no less than 24 ℃，the unit automatically selects cooling
mode, and when the room temperature is less than 24 ℃， the unit automatically selects fan mode.
• Drying mode
The fan runs at a low speed. The fan speed and temperature cannot be adjusted.
The compressor will stop after 8 minutes of running and then run again after 6 minutes.
• Cooling mode
When the room temperature is higher than the set temperature, the compressor starts to run.
When the room temperature is lower than the set temperature, the compressor stops and the fan
operates at the original set speed.
Note: When the compressor is working, the unit will vibrate slightly. This is normal and harmless.
• Heating mode
When the room temperature is higher than the set temperature, the unit will stop the heating function.
When the room temperature is lower than the set temperature, the unit will start the heating function.
"/" " to set your desired room temperature from 15℃ to 31℃. The buttons can
- 8 -