Low Heating; Ash Removal; Extinguishing The Fire; Weather Conditions - Dovre 300G Installation Et Mode D'emploi

4.5. Low heating (for devices suitable for continuous use)
To use the device as a 'continuous fire', you can select the primary and secondary air
scoops in such a way you get the right burning speed. Always make sure there's
enough glow on the heating bottom.
4.6.

Ash removal

By using the shovel, you can remove the ashes adequately and gather them in the
ashtray. The ashtray can be removed from the appliance by means of the supplied
"cold" hand (see picture).
Relatively speaking, burning wood produces little ash and
it will not be necessary to remove it each time daily. More-
over, wood burns better on a bed of ash.
When you heat with coals, the ashes should be removed on
a regular basis and the ashtray should be emptied fre-
quently. The ashes must NEVER reach the underside of the
heating grate.
4.7.

Extinguishing the fire

Stop fuelling the fire and let it burn out.
Damping a fire by closing the air slides involves the release of noxious gases. You
should let the fire burn out and keep an eye on it as long as it is still glowing.
4.8.

Weather conditions

Attention!
Mist and heavy fog will block the chimney's fume outlet and may lead to smoke emis-
sion into the living room.
It is best not to use the stove under these weather conditions.
300G / 310GX
35
03.27635.000