Replacing Carbon Brushes; Service Parts List - Hitachi C 7SB2 Instructions De Sécurité Et Mode D'emploi

NOTE:
Use HITACHI carbon brush No. 38 indicated in Fig. 17.

4. Replacing carbon brushes:

Remove the brush caps with a slotted-head screwdriver. The
carbon brushes can then be easily removed. (Fig. 18)
5. Performance checkup and maintenance of safety cover
Keep the safety cover in good shape for smooth performance
at all times. Be sure to make prompt repair in case of any
malfunction.
6. Adjusting the base and saw blade to maintain
perpendicularity
The angle between the base and the saw blade has been
adjusted to 90°, however should this perpendicularity be lost
for some reason, adjust in the following manner.
(1) Turn the base face up (Fig. 19) and loosen the lever (A).
(2) Apply a square to the base and the saw blade and, turning
the slotted set screw with a slotted-head screwdriver, shift the
position of the base to produce the desired right angle.

7. Service parts list

CAUTION:
Repair, modifi cation and inspection of Hitachi Power Tools must be carried out by a Hitachi Authorized
Service Center.
This Parts List will be helpful if presented with the tool to the Hitachi Authorized Service Center when
requesting repair or other maintenance. In the operation and maintenance of power tools, the safety
regulations and standards prescribed in each country must be observed.
MODIFICATIONS:
Hitachi Power Tools are constantly being improved and modifi ed to incorporate the latest technological advancements.
Accordingly, some parts (i.e. code numbers and/or design) may be changed without prior notice.
Brush Cap
Slotted-head
Screwdriver
Fig. 18
Square
Slotted Set Screw
Fig. 19
English
Base
15