Buhnen HB 230E Mode D'emploi page 14

Operation
3.2.3 Status Messages and Error Indicators
Display
Decimal point
left flashes
ERR
F1L
F1H
--
EP
3.3 Adjustments on the Unit
The stroke limit allows the front end position of the trigger to be adjusted.
This allows the user to
• achieve a comfortable trigger setting for himself or
• adjust precise metering of the filling material for each working stroke.
To set the stroke limit, please carry out the following steps:
1. Loosen the locknut (6a).
2. Adjust the setting screw (6) so that the trigger has the required initial posi-
tion, or so that the required filling material quantity is applied per working
stroke.
3. Tighten the locknut (6a) to secure the setting.
3.4 Notes on Gluing
Please observe the following tips and information so that you are able to
continuously achieve perfect material bonding.
Cause
Heating up phase is active
Exceeding the maximum
temperature
Sensor error, short circuit
Sensor error, sensor
defective
Key disabling active
Data loss in the parameter
memory
14
Action
The heating up phase is over
when the set alue has reached
just under 2 degrees.
Leave it to cool down.
Check the sensor
The error indicator also dis-
plays after the error has been
eleiminated until it is confirmed
with the DOWN key.
Check the sensor
The error indicator also dis-
plays after the error has been
eleiminated until it is confirmed
with the DOWN key.
see parameter P19
Repair of the regulator
GB