Safety Warnings - Nicols BP DOT Manuel D'utilisation

Thank you very much for choosing our product. For safety purpose, please read this manual carefully before your
operation. This manual included installation and using information. Please install and operate it according to this
manual.

SAFETY WARNINGS

WARNING :
another user, be sure that they also receive this instruction booklet.
Caution：

All fixtures are intact from the manufacturer, please operate follow up the user manual, artificial fault are not
under guarantee repair.

Unpack and check carefully there is no transportation damage before using the unit.

Do install and operate by operator.

Use safety chain when fixes the unit.

The unit must be installed in a location with adequate ventilation, at least 50cm from adjacent surfaces.

Before operating, ensure that the voltage and frequency of power supply match the power requirements of
the unit.
It's important to ground the yellow/green conductor to earth in order to avoid electric shock.

Maximum ambient temperature: 40℃. Don't operate it where the temperature is higher than this.

Don't connect the device to any dimmer pack.


First run, there will be smoke or smells, and all disappearing a few minutes later.

Make sure there are no flammable materials close to the unit while operating, as it is fire hazard.

Look over power wires carefully, replace immediately if there is any damage.
Unit surface temperature may reach up to 60℃. Don't touch the housing bare-hand during its operation.


Never run on for a long time lest shortening lifespan.

Avoid any inflammable liquids or metal objects entering the unit. Once it happen, cut off the mains power
immediately.

The fixtures must be cleaned regularly if they are in a dirty and dusty environment

Do not allow children to operate the fixture.

Do not touch any wire during operation as there might be a hazard of electric shock.

Avoid power wires together arounding other cables.

Replace fuse only with the same type.

In the event of serious operating problem, stop using the unit immediately.

Never turn on and off the unit time after time.

Do not open the unit as there are no user serviceable parts inside. Never try to repair the unit by yourself.
Repairs carried out by unskilled people can lead to damage or malfunction. Please contact the nearest
authorized technical assistance center.

Disconnect the mains power if the fixture is not used for a long time.

Do use original packing materials once transport it again.

Do not look directly at the LED light beam while the fixture is on.
PRODUCT
Product introduction
This product is designed for indoor use. Suitable applications include wash, effect lighting for architectural, stage
or nightclub applications. This product can also be installed for use in signage and advertising using the dynamic
functions available with DMX512 control. Direct input of DMX512 signal allows the units to be controlled from any
DMX512 controller. This product can be operated as a single unit or in multiple units for large applications.
Please keep this User Guide for future consultation. If you sell the unit to