Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

.
1
CAUTION
Keep this device away from rain and moisture! Unplug mains lead before opening the housing.
For your own safety, please read this user manual carefully before using the fixture.
- follow the instructions of this manual
- consider this manual to be part of the total produce
- keep this manual for the entire service life of the product
- pass this manual on to every further owner or user of the product

2. SAFETY INSTRUCTIONS

This device has left our premises in absolutely perfect condition. In order to maintain this condition
and to ensure a safe operation, it is absolutely necessary for the user to follow the safety instructions
and warning notes written in this user manual.
IMPORTANT:
Damages caused by the disregard of this user manual are not subject to warranty.
The dealer will not accept liability for any resulting defects or problems.
Always plug in the power unit least.
Keep away from heaters and other heating sources!
If the device has been exposed to drastic temperature fluctuation(e.g. after transportation), do not
switch it on immediately. The arising condensation water might damage your device. Leave the switched
off until it has reached room temperature.
This device falls under protection-class III. The device always has to be operated with an appropriate
transformer.
Always disconnect from the mains, when the device is not in use or before cleaning it.
Please note that damages caused by manual modifications on the device or unauthorized operation by
unqualified persons are not subject to warranty.
Keep away children and amateurs from the device!
There are no serviceable parts inside the device. Maintenance and service operations are only to be
carried out by authorized dealers.
3. OPERATION
This device is a DMX-controller for controlling DMX-effects or spots in discotheques, on stages etc.
This product is allowed to be operated with a direct voltage of DC 12-20V,500mA and was designed
for indoor use only.
Do not shake the device. Avoid brute force when installing or operating the device.
When choosing the installation-spot, please make sure that the device is not exposed to extreme heat,
moisture or dust. There should not be any cables lying around, you endanger your own and the safety
of others!
This device must never be operated or stockpiled in surroundings where splash water, rain, moisture or
fog may harm the device. Moisture or very high humidity can reduce the insulation and lead to mortal
electrical shocks. When using smoke machines, make sure that the device is never exposed to the
direct smoke jet and is installed in a distance of 0.5 meters between smoke machine and device. The
room must only be saturated with an amount of smoke that the visibility will always be more than 10
meters.

Publicité

Table des Matières
loading

Table des Matières