Reload manufacturer's Data
Press SET-button until displays SET (Set menu)
Press ENTER
Press UP or DOWN to browse to Load Parameter
Press ENTER
Press UP or DOWN to browse to ON (reload)/OFF (do not reload)
Press ENTER to confirm.
Stand-alone mode
In Stand-alone mode, the lighting out of control of any exterior signal, run solely. Setting method is:
Press MODE-button until shows SET (set menu)
Press ENTER-button
Press UP or DOWN-button to browse to Master / Alone
Press ENTER-button
Press UP or DOWN-button to browse to ALON (alone)
Press ENTER - button to confirm.
Set Auto /sound mode
The steps to set Auto/sound mode:
Press MODE-button until shows SET (set menu)
Press ENTER-button
Press UP or DOWN-button to browse to Auto / Sound
Press ENTER-button
Press UP or DOWN-button to browse to Auto Mode/ Sound Mode
Press ENTER - button to confirm.
DMX mode
In DMX mode,the lighting can controlled by controller. When the display shows A001 or the other actual stored
addresses .the lighting is in DMX mode.
Selecting channels mode
When the lighting is in DMX mode, and showing the stored address,
Press ENTER, shows DMX (DMX menu)
Press ENTER
Press UP or DOWN to browse to DMX Channels
Press ENTER to STAG Mode
Press ENTER to browse to 16/13/8/6
Press UP or DOWN to browse, Press ENTER to confirm
Setting DMX start address
In DMX mode, a fixture requiring one or more channels for control begins to read the data on the channel
indicated by the start address. For example, a fixture that uses 3 DMX channels and was addressed to start on
DMX channel 1, would read data from channels: 1, 2, 3. Choose start addresses so that the channels used do not
overlap, and note the start address selected for future reference. Note that assign the same address to the
different lightings, they will receive the same signal.
Setting DMX address method:
When the lighting is in DMX mode, and showing the stored address,,
Press ENTER, shows DMX (DMX menu)
Press ENTER