Disposal And Recycling - Dexter power TS8 Traduction Des Instructions D'origine

Important information
In the event of an overloading the motor will switch
itself off. After a cool-down period (time varies) the
motor can be switched back on again.
Damaged electrical connection cable
The insulation on electrical connection cables is often
damaged.
This may have the following causes:
• Passage points, where connection cables are
passed through windows or doors
• Kinks where the connection cable has been im-
properly fastened or routed
• Places where the connection cables have been cut
due to being driven over
• Insulation damage due to being ripped out of the
wall outlet
• Cracks due to the insulation ageing
Such damaged electrical connection cables must not
be used and are life-threatening due to the insulation
damage.
Check the electrical connection cables for damage
regularly. Make sure that the connection cable does
not hang on the power network during the inspection.
Electrical connection cables must comply with the ap-
plicable VDE and DIN provisions. Only use connec-
tion cables with the marking "H05VV-F".
The printing of the type designation on the connection
cable is mandatory.
If it is necessary to replace the connection cable, this
must be done by the manufacturer or their represent-
ative to avoid safety hazards.
AC motor:
• The mains voltage must be 220-240 V ~ .
• Extension cables up to 25 m length must have a
cross section of 1.5 mm .
2
Connections and repairs of electrical equipment may
only be carried out by an electrician. Please provide
the following information in the event of any enquiries:
• Type of current for the motor
• Machine data - type plate
• Motor data - type plate
36 | GB

15. Disposal and recycling

The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled.
The equipment and its accessories are made of vari-
ous types of material, such as metal and plastic. De-
fective components must be disposed of as special
waste. Ask your dealer or your local council.
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must not
be disposed of together with domestic waste in
compliance with the Directive (2012/19/EU)
pertaining to waste electrical and electronic
equipment (WEEE). This product must be disposed
of at a designated collection point. This can occur, for
example, by handing it in at an authorised collecting
point for the recycling of waste electrical and elec-
tronic equipment. Improper handling of waste equip-
ment may have negative consequences for the envi-
ronment and human health due to potentially
hazardous substances that are often contained in
electrical and electronic equipment. By properly dis-
posing of this product, you are also contributing to
the effective use of natural resources. You can obtain
information on collection points for waste equipment
from your municipal administration, public waste dis-
posal authority, an authorised body for the disposal
of waste electrical and electronic equipment or your
waste disposal company.