Accessories; Fault Finding - Bosch AXT Rapid 2000 Notice Originale

F 016 L70 461.book Seite 5 Montag, 29. November 2010 5:31 17

Accessories

Blade ................................................F 016 800 276
Collection bag................................... 2 605 411 073
Gloves .............................................. 2 607 000 134
Protective goggles ............................ 2 607 990 041
Lubricant spray ................................. 1 609 200 399

Fault Finding

The following table gives checks and actions that you can perform if your machine does not operate correctly.
If these do not identify/remedy the problem, contact your service agent.
Warning: Switch off and remove plug from mains before investigating fault.
Symptom
Machine fails to operate
Machine functions
intermittently
Poor cutting performance Cutting blade blunt
16 • F 016 L70 461 • TMS • 23.11.10
Possible Cause
Switch fails to operate
Securing knob 3 has not been fully
tightened
Power turned off
Mains socket faulty
Extension cable damaged
Fuse faulty/blown
Motor protector has activated
Power supply interrupted
On/Off switch 2 returns to position "0"
Extension cable damaged
Machines internal wiring damaged
Motor protector has activated
On/Off switch 2 returns to position "0"
Cutting blade dirty
Feed intake or discharge
blocked
English - 5
After Shredding/Storage
Stop and remove plug from the power sup-
ply.
Clean the exterior of the machine thoroughly using a
soft brush and cloth. Do not use water, solvents or
polishes. Remove all debris, especially from the
ventilation slots 5.
Store the machine in a dry place. Do not place other
objects on top of the machine.
For additional security the switch can be padlocked
(padlock not supplied) as shown in fig.
Remedy
Follow "Restart Protection" procedure
(Starting and Stopping)
Do not push On/Off switch 2 while it is
being rotated
Tighten securing knob 3
Turn power on
Use another socket
Inspect cable, replace if damaged
Replace fuse/restart
Follow "Overload Protection" proce-
dure (Starting and Stopping)
Follow "Overload Protection" proce-
dure (Starting and Stopping)
Allow machine to cool then follow
"Overload Protection"
(Starting and Stopping)
Inspect cable, replace if damaged
Contact Service Agent
Follow "Overload Protection" proce-
dure (Starting and Stopping)
Allow machine to cool then follow
"Overload Protection"
(Starting and Stopping)
Replace blade (see "Blade Mainte-
nance")
Remove blade and clean (see "Blade
Maintenance")
chute Clean machine (see "Removing Block-
age") and empty collecting bag
D .
procedure
procedure