Introduction; Main Technical Specifications - Scale House HLD150 Notice D'utilisation

1. INTRODUCTION

This manual was created to help you install and learn all about the functional possibilities of the HLD scale.
The scales should be sited in a location that will not degrade the accuracy.
Avoid extremes of temperature. Do not place in direct sunlight or near air conditioning vents.
Avoid unsuitable tables. The tables or floor must be rigid and not vibrate. Do not place near vibrating machinery.
Avoid unstable power sources. Do not use near large users of electricity such as welding equipment or large motors.
Avoid high humidity that might cause condensation. Avoid direct contact with water. Do not spray or immerse the scales in
water.
Avoid air movement such as from fans or opening doors. Do not place near open windows.
Keep the scales clean.
Do not stack material on the scales when they are not in use.

2. MAIN TECHNICAL SPECIFICATIONS

Model Plate
dimensions
mm
HLD150 Φ80mm
HLD300 Φ120mm
HLD600 Φ120mm
HLD1500 140x150mm
HLD3000 140x150mm
HLD6000 140x150mm
(*) Standard and HR division selectable in weighing phase, through the unit of measure conversion function, see section
6.8.
Stabilisation Time
Operative Temperature:
Power supply:
Battery life:
Recharge time:
Parameter Setup:
Display :
Case:
Zero range:
Auto zero at start-up:
WARNINGS
Capacity Standard
Division
g g (*)
150 0,02
300 0,05
600 0,1
1500 0,2
3000 0,5
6000 1
2 Seconds typical.
5°C - 40°C / 32°F - 104°F.
with fitted 240 Vac mains power adapter or with fitted battery
up to 30 hours of continuous use.
12 hours.
Calibration fully digital and programmable from the keyboard.
LCD backlit with 6 ½ digits 16 mm high
ABS Plastic.
+/- 2% of max load capacity.
+/- 10% of max load capacity.
HR Linearity
Division
g (*) g +/-
0,002 0,004
0,005 0,01
0,01 0,02
0,02 0,04
0,05 0,1
0,1 0,2
.
4
Internal Min. APW
sensitivity recommended
g g
0,0002 0,002
0,0005 0,005
0,001 0,01
0,002 0,02
0,005 0,05
0,01 0,1