Pro-User IBT1 Mode D'emploi page 7

Please Read Carefully Before Using The Device
This system is intended to be used only with 6V & 12V & 24V DC batteries, e.g. Lithium and Lead-Acid
batteries e.g. Wet, Maintenance-Free-, Gel, Calcium-, (VRLA-)AGM, Deep-Cycle-batteries
Preparing The Battery
Follow your battery manufacturer´s and vehicle´s manufacturer´s precautions and preparatory
measures, if disconnecting the battery from your vehicle´s 6V/12V/24V system is necessary to install
the device.
Connecting The Ring Terminal Cables
Connect the clamps to the battery in the following order:
"Check & Charge"-Interface
Use the conveneint Pro-User "Check & Charge"-Interface to easily connect to a compatible Pro-User IBC
batery charger
Ideal in combination
with the following
Pro-User battery chargers:
OPERATION
1. Connect the RED connection cable to
the positive terminal post of the
battery (marked +).
2. Connect the BLACK connection cable
to the negative post of the battery
(marked -).
It is important to ensure that all
connections are making good contact
with their respective terminal posts.
3. You can easily connect a compatible
Pro-User "Check & Charge" IBC charger
to the IBT1 to recharge your battery.
7