Assembly; Use - Cleanmaxx EL17001-00100 Mode D'emploi

Assembly

1. Plug the telescopic rod (2) into the recess on the top of the motor unit (5).
2. Place the hanger (1) onto the telescopic rod (2). When you do this, make sure that the
slight bend in the hanger (1) points forwards. The drip protection (3) must be located
directly above the fan (4). It prevents any water that may drip down from being able
to get into the fan (4).
3. Attach the nylon balloon:
– Pull it over the hanger (1). When you do this, make sure that the side with the hole
line points forwards.
– Pull the small elastic cord at the top over the collar section (10) on the hanger (1).
– Pull the large elastic cord at the bottom over the mounting fl ange (8).
The device is disassembled in the reverse order.

Use

NOTE!
■ Always place the device with clear space above it and on all sides on a dry, fl at, solid
and heat-resistant surface.
■ It is essential that you follow the care labels for the textiles to be dried!
00384_DE-EN-FR-NL_A5_V4.indb 15 00384_DE-EN-FR-NL_A5_V4.indb 15
15
1. Set the height you want. To do this, open the clip (9), pull
out the telescopic rod (2) and then close the clip (9) again.
2. If you have not already done so, pull on the nylon balloon
(see the "Before Initial Use" chapter, "Assembly" section).
The nylon balloon should sit immediately below the
mounting fl ange (8) so that it can fully infl ate.
EN
07.12.2017 08:57:52 07.12.2017 08:57:52