Setting Up; Setting Up The Receiver; Inserting And Testing Batteries In The Handheld Transmitter Dht 70; Inserting And Testing Batteries In The Bodypack Dpt 70 Transmitter - Harman AKG DMS 70 Quattro Mode D'emploi

4 Setting up

Setting up the receiver

Inserting and testing batteries in the
handheld transmitter DHT 70
Inserting and testing batteries in the
bodypack DPT 70 transmitter
DMS 70 Quattro/Dual DMS 70 DMS 70 DMS 70
Press the On/off switch (1) to switch the receiver on. This green button is illuminated when
the receiver is ready for use.
1) Unscrew thebattery cover (14) from the handheld transmitter.
2) Lift up the two battery compartment covers.
3) Insert the supplied batteries into the battery compartment conforming to the polarity
marks.
The transmitter will not function if you insert the batteries the wrong way round.
4) Close the two battery compartment covers.
5) Switch on the transmitter with the On/Off button (15).
If the status LED (13) flashes green, the batteries are in good condition but there
is no radio contact with the receiver. The transmitter must be connected to the
receiver.
If the status LED is lit green, the batteries are in good condition and there is radio
contact between the transmitter and receiver. Speak or sing into the microphone.
If the status LED goes red the batteries are likely to be flat in approx. 1 hour.
Replace with new batteries as soon as possible.
If the status LED does not light up the batteries are flat or possibly incorrectly fitted.
Insert new batteries or insert the existing batteries correctly. Check for the correct
polarity.
6) Screw on the battery cover tightly.
1) Depress the snap hook on the battery compartment cover (22).
2) Pull the battery compartment cover down and off the transmitter.
3) Insert the supplied batteries into the battery compartment conforming to the polarity
marks.
The transmitter will not function if you insert the batteries the wrong way round.
4) Slide the slide cover (20) to the rear position and switch on the transmitter using the
on/off switch (15).
If the status LED (13) flashes green, the batteries are in good condition but there
is no radio contact with the receiver. The transmitter must be connected to the
receiver.
If the status LED is lit green, the batteries are in good condition and there is radio
contact between the transmitter and receiver.
If the status LED goes red the batteries are likely to be flat in approx. 1 hour.
Replace with new batteries as soon as possible.
If the status LED does not light up the batteries are flat or possibly incorrectly fitted.
Insert new batteries or insert the existing batteries correctly. Check for the correct
polarity.
5) Push the slide cover over the on/off switch to prevent the transmitter from being switched
on/off inadvertently.
6) To close the battery compartment, slide the battery compartment cover onto the battery
compartment from below until the snap hook engages.
Setting up
33